How To Make Sandblasted Signs
Beginning of paper
I am going to tell you how you can make a sandblasted sign. The only
necessary tools you need are: bass wood, or red wood, rubber masking, spray
glue, exacto knife, sand paper, paint (which most of these items you can find at
your local hardware store). Also you need to know someone in your comm ....
Middle of paper
.... Now you are ready to put your design on the rubber masking. Apply the
spray glue to the rubber masking. Once you have sprayed the glue (in a well
ventilated area) to the masking you should wait for about 2 minutes for the
adhesive to dry, and begin to cut out your design you have chosen. This is a
very time consuming task so it is best to take your time.
This is the time to start cutting on your masking. It is best to leave
about one half of an inch around the outside edge of the b ....
------------------
Word count: 625
Page count: 3 (approximately 250 words per page)
